Formica Argento Romano - Laminate Kitchen Countertops

Some Ideas on Formica — Custom Countertop Creations You Should Know

Beginning with the proper substrate develops a good foundation for the counter top. Particleboard has a uniform, clear surface best for accepting the contact cement and leaving a smooth finish. Sadly, it doesn't come any thicker than 34 inch, which isn't enough for a countertop. You'll need to double up at the edges to develop a 1-inch face and raise the counter greater.

Formica Solid Surfacing Beautifies Home Spaces

Nevertheless, he makes certain to paint the underside of any counter that will sit over a dishwasher, cleaning maker, or dryer with a thick coat of guide to secure against wetness. Pasting the laminate to the particleboard is the trickiest part of building a counter. Two surface areas coated with contact cement bond the minute they touch.

" Since once it's stuck, it's stuck." Separating the two surface areas with dowels will provide you the possibility to line everything up prior to you adhere the parts. There's a series to the method you laminate any counter in order to conceal noticeable edges.  Learn More Here  go on initially, then the front edge, and finally the top.

The Formica Countertops - Zuern Building Products Ideas

Matching laminate edges is very hard, which is likewise why you must prepare for as couple of seams as possible; if they are essential (as with an L-shaped surface area, like the one revealed here), your best option is to laminate 2 pieces independently, then join them. You can likewise choose to make a backsplash piece, which attaches to the back of the counter prior to you mount the entire piece to the cabinets or the wall.

Cut 4-inch strips of particleboard to line the underside of each edge. Glue and screw the strips to the sheet with 1-inch screws. Ensure the edges are completely flush. If you will be linking two countertop sections, size and set up the strips on one piece to extend beyond completion of the sheet and fit under the nearby piece (see overview).

Dry-fit the counter top sections prior to laminating them, and ensure pieces fit tightly. Sand the seam with 100-grit paper to fix any inequalities. To make an actually tight joint between 2 particleboard pieces, back-cut the end of one piece by tilting your circular saw blade to 5 degrees. Cut the laminate Carefully unroll the laminate and lay it on a flat surface, faceup.